Beneteau 62 “Mystic”

General  Sails and dimensions 
L.O.A max19,16m62’10’’Mainsail:93m²1,001 sq ft
Hull length:18,13m59’6’’Genoa(106%):83m²893 sq ft
L.W.L.:17,88m58’8’’Code 0:165m²1,776 sq ft
Beam:Deep draft:5,33m 2,98m17’6’’ 9’9’’Staysail:36m²387 sq ft
Deep ballast:5 900kg13,004Rigg Dimensions  
Air draft:27,75m91’1’’I        23,59m77’5’’ 
Light displacement:26 108kg57,542J        7,21m23’8’’ 
Fuel capacity:1 000L264 USP       23m75’6’’ 
Fresh water capacity:1 060L280 USE       7m23’ 
Engine power:170 HP126 KW   
EC Certification  
Architects / Designers
Category A:12 peopleNaval Architect:Berret-Racoupeau esign
Category B:14 peopleDesign:Andreani Design
Category C:16 people

CONSTRUCTION

Design in accordance with European Directive requirements and according to CE certification. Composition: Polyester resin

  • Infused balsa sandwich hull
  • Infused solid laminate base of hull
  • Deck in balsa and fiberglass sandwich covered in “diamond point” type non-slip surface
  • Screwed, glued and bolted polyester hull-to-deck joint
  • Cast iron keel fixed with bolts and stainless steel backing plates
  • Twin rudders hung with stainless steel stock

DECK FITTINGS

All the sail trim of the Oceanis 62 is brought back to the helm stations Winches (accessible from each helm station)

  • 2 Electric genoa sheet winches (Code 0 / Spinnaker) – self tailing 70.2 STC
  • 2 Electric primary winches (H50.2 STECH)
  • 2 Speedgrip winch handles
  • 2 Winch handle holders

Mooring

  • Stainless steel bowsprit with single stem roller, Tack for asymmetrical spinnaker or Code 0
  • Self-draining chain locker
  • Lockable access panel to the chain locker in the sail locker
  • 24 V – 2 000 W vertical electrical windlass – Remote control
  • Windlass control in cockpit with chain counter
  • 8 Stainless steel mooring cleats (400mm / 1’4’’)

Fore sail locker

  • Access through deck hatch (T70), Passage width: 62 cm / 2’
  • Stainless steel ladder
  • Locker fitted with stowage designed for lines, fenders, cushions, sails, etc.
  • Direct access to the anchor well, Panel: T44

Safety on deck

  • 1 Stainless steel pulpit in 2 parts, open at the bow (750mm – 28mm diameter)
  • 2 Stainless steel pushpits (750mm – 28mm diameter)
  • 1 Lifebuoy support bracket
  • 1 Ensign mount
  • Triple guard wires and stainless steel stanchions (Height: 750mm) – side boarding gate on either side
  • 4 Stainless steel handrails on deck:
  • 4 Stainless steel handrails on fixed arch

Cockpit

  • Self-draining cockpit floor, teak slats, black joints
  • Life raft stowage in locker in the cockpit sole
  • 2 Lockers in the return of the cockpit seats, gas strut opening
  • 1 Locker beside the port helm console
  • 1 Gas locker beside the starboard helm console
  • 2 Teak slats on cockpit benches
  • 2 Helm stations:
  • Deck plates for tiller system – Emergency steering
  • Engine throttle and control panel on both helm positions
  • 2 Teak cockpit tables with 2 stainless steel high-low pedestals electric operated
  • LED lights in cockpit, transom, and forward sun pad
  • Cockpit fridge near the port helm station, 40L, top opening
  • 2 Sunbed mattresses for companionway, Diamante Snow
  • PMMA companionway doors & sliding companionway hatch
  • Fresh/sea water pump for deck cleaning

Aft cockpit

  • Large stowage locker under aft central seat
  • 2 Lifting helm seats for access to the bathing platform steps
  • Shore power socket

Aft transom

  • Access to the sea from electric fully opening transom with gas strut, converting to bathing platform
  • 1 Steps behind each helm station
  • Access to the tender garage
  • Teak slatted swim platform
  • 1 Built-in stainless steel bathing ladder
  • 1 Hot and cold cockpit shower
  • 1 Stainless steel chain plate (for mooring of the tender at anchor)

Tender garage

  • 1 Access hatch in the cockpit sole between the 2 helm stations for access without opening aft platform
  • Tender garage: 3,49 x 1,70m / 11’5’’ x 5’7’’
  • 3 Lights
  • Canvas cover to close tender compartment and textile stowage bags
  • Inflater / deflater for tender

ENGINE AND ELECTRIC POWER SUPPLY

  • Yanmar engine:          170 HP, 6 cylinders, propeller shaft
  • Engine electrical control and switchboard with dual controls
  • Bow thruster
  • Stern thruster
  • Engine compartment: foam soundproofing: 40mm – ventilation: 4 air intakes & 2 air extractors
  • 1 Alternator (12V – 150 Amps)
  • 1 Alternator (24V – 90 Amps)
  • 3000W inverter
  • 100A Battery charger on shore power
  • 17,5 kVA Onan Generator – with automatic switch off in fully insolated cocoon
  • 3 Fuel tanks (2 x 230L + 1 x 540L / 2 x 61 US Gal +1x 143 US Gal) – Electronic gauge – 3 Deck fillers – Tank selection with “¼ turn” by-pass valves
  • Filters: Seawater – Diesel – Water separator
  • 3 folding blades propeller
  • Access to the engine compartment: Companionway (gas strut opening) & starboard machinery compartment

PLUMBING

  • 4 rotomoulded freshwater tanks (1 x 400L + 3 x 200L / 1 x 106 US Gal + 3 x 53 US Gal) – 4 Deck fillers – Tank selection with “¼ turn” by-pass valves
  • Pressurized electric water pump – expansion tank – inline filter
  • 60 L Electric water heater (16 US Gal)
  • 1 Rigid 80 L / 21 US Gal black water holding tank for each WC
  • Automatic electric shower drain pumps – time delay
  • 2 Electric bilge pumps – 1 manual bilge pump
  • Water maker capacity on 220v 150l – hour

ELECTRONICS PACKS B&G

  • Port and starboard helm stations with each Zeus3S 12’’ Multifunction screen (GPS, Chart plotter)
  • H5000 units
  • Chart table: 1 Zeus3S 16’’ Multifunction screen (GPS, Chart plotter)
  • B&G ZC2-series remote keyboard
  • H5000 auto pilot with control at the 2 steering positions
  • WR 10 Wireless autopilot remote control
  • Fixed V100B VHF (with AIS) + 2 H60 handsets
  • Epirb

Rigging

  • Classic black lacquered mast with canoe boom with and hydraulic boom vang
  • Hydraulic boom vang
  • Electric genoa furling system
  • Asymmetrical spinnaker rigging + Code 0 rigging
  • Self-tacking jib hardware
  • Self-tacking staysail rigging
  • Hydraulic backstay
  • Genoa sheet track leads adjustable from the cockpit
  • LED spreader lighting on all levels
  • Flag halyards

Sails

  • Vectran tri-radial cut mainsail and genoa
  • Laminated Mylar/Taffetas code 0 with electrical furling drum
  • Vectran self-tacking staysail with manual furling

Special options

  • Reversible air conditioning in all cabins and saloon.
  • Electrical toilets in each head
  • Underwater lights
  • Teak on roof
  • Teak on side decks
  • Retractable aluminum cleats replacing the standard cleats
  • Rope cutter
  • Underwater lights (x 4)
  • Telescopic hydraulic gangway + 2 Remote controls
  • Dinghy ramp (rollers in the garage door + electric winch in the tender garage + control)
  • Carbon steering wheels
  • Hard top, canvas opening roof, integrated lights
  • Rigid windscreen
  • Sprayhood for rigid windscreen
  • Electric legs for cockpit tables + table cover
  • Cockpit tables with extension leaf + covers (grey PVC) + electric pedestal
  • Sunbed for cockpit table on electric feet
  • Cockpit galley electric plancha + Sink + 1 Secret (pop-up) LED lighting
  • Shore fresh water supply
  • TV 40”on lifting system in the saloon
  • TV 32”in owners cabin
  • Satellite TV antenna
  • Onboard Wifi
  • 6 Waterproof speakers ouside
  • Fusion sound system
  • Bose loudspeakers in saloon
  • Crew cabin in bow
  • Dishwasher
  • Washer Dryer 5kg (220v)
  • Electric cooking (220v)
  • Micro wave (220v)
  • Wine fridge with glass door
  • Additional fridge near galley

Gallery

Facebook
Twitter
LinkedIn